2000 mazda / Ranger Door Bell
#1
2000 mazda / Ranger Door Bell
I just recently replaced some burnt out dash lights (what a fun job!) and during the re-assembly a misc. switch assy. became detached from the steering column near the ignition switch and I was not sure if I put it back into the right place.
Now, when the driver door is opened, it rings (dings) irriitatingly fast until you close the door.
Also, the warning that your lights are on after you turn the engine off no longer works. I opened up the column cover again ,but I cannot figure out where it goes. The Hanes manual I just purchased is not much help.
Any ideas?
Thanks..........................Bill
Now, when the driver door is opened, it rings (dings) irriitatingly fast until you close the door.
Also, the warning that your lights are on after you turn the engine off no longer works. I opened up the column cover again ,but I cannot figure out where it goes. The Hanes manual I just purchased is not much help.
Any ideas?
Thanks..........................Bill
#3
Thread
Thread Starter
Forum
Replies
Last Post