Metal guage
Thread Starter
|
FTE Legend
Joined: Aug 2004
Posts: 37,887
Likes: 20
From: North Central Rural Sask.
Metal guage
I was curious, do any of you know, what 29 gauge sheet metal would be in a measurement. Like would it be 1/16th on an inch, stc.? Is there any way to figure that out..??
Hotshot
Joined: May 2004
Posts: 12,170
Likes: 5
From: The hills of No. Calif.
It seems to vary depending on what the type of metal is. Ungalvanized steel is .0135
Take a look at this:
http://www.unc.edu/~rowlett/units/sc...heetmetal.html
Take a look at this:
http://www.unc.edu/~rowlett/units/sc...heetmetal.html
Last edited by TigerDan; Jan 8, 2006 at 07:56 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Shepard
General NON-Automotive Conversation
9
Sep 22, 2004 02:38 PM
