exhaust help
Thread Starter
|
Senior User
Joined: Aug 2005
Posts: 140
Likes: 0
From: utah
exhaust help
I bought a 2000 f-350 psd with a huge exhaust system. I am not sure what kind it is or the diameter. Just by looking i would say it is 4 or 5 inches. When the previous owner put it on the truck was at stock level and they had to use angles to clear the axle. Since I purchased the truck I have installed a 6.5 inch lift and now the exhaust hits my leaf spring. I want to cut it back and straighten it out and re-rout it alittle but there are no muffler shops in my town that can get pipes that big and if they could, they dont have the bender. I can't afford to replace it and I like the exhaust anyway. Any ideas on where to come up with some pipe? Thanks
Posting Guru
Joined: May 2004
Posts: 2,161
Likes: 1
From: Prince George, B.C.
Any shops that do systems for Semis? They should have the bender for that. You could always use the bends from it to shorten it and put it out in front of the pass. side tire or just dump it under the truck. All you need is a welder for that depending on the pipe.
Its Comin Right for us!
Joined: Feb 2005
Posts: 12,161
Likes: 2,639
From: GA
their current site is under construction, but this temp site still shows most of their stuff. you cant get most any pipe or fitting from them, jegs and summit have alot of stuff as well.
http://store.airflo.com/
if you look in my galerry, i built my single 4 inch system easily with parts from jegs.
http://store.airflo.com/
if you look in my galerry, i built my single 4 inch system easily with parts from jegs.
Thread
Thread Starter
Forum
Replies
Last Post
blueovalbigblock
1994.5 - 1997 7.3L Power Stroke Diesel
18
Dec 12, 2010 08:47 PM
