240 torque specs
Thread Starter
|
New User
Joined: Mar 2005
Posts: 12
Likes: 0
From: north Ga
240 torque specs
I am doing a backyard overhaul on the 67 F100,The block was previously bored 030 and crank 010.
Would like to do something on a 300 or 302 later when I have enough spare $ to do it right.
I have cleaned thing up(engine out) cut ridge out and honed clylinders.have new mains in and crank set.Need torque on main,rods and head.I hope to re-use pistons,have done in on gas tractor engines,how do yall fell about that?I thought they were alum. but not sure,they are not cast.
Steve
Would like to do something on a 300 or 302 later when I have enough spare $ to do it right.
I have cleaned thing up(engine out) cut ridge out and honed clylinders.have new mains in and crank set.Need torque on main,rods and head.I hope to re-use pistons,have done in on gas tractor engines,how do yall fell about that?I thought they were alum. but not sure,they are not cast.
Steve
Thread
Thread Starter
Forum
Replies
Last Post
