hi from aussie can you bore a 330 ft if so how far and can i resleve it the casting on the block is C6ME.A 1M

 

you can go ithink up to 60 over depending on the wall thickness . why would you resleve it.

 

didn,t no if i had to or not but 60 th so i could make a 391 out of it yet ?

 

if i were you i would keep it a 330 or just drop in a fe

 

What is the bore on a 330? Are they about the same as the 352, with a shorter stroke? A 352 has a 4.00" bore, at 050" over, you can make 360/390/410 etc. You would not be using much from the 330, but the block.

 

the bore is 3.875 330 hd . that,s one of the motor,s i have the 2nd one has 2T on the crank and the fly wheel end has a cut out (little moon cut out )
same bore size as the 330hd they have 2 diff rod,s in the two motor,s so i no i have two diff crank,s and 2 diff rod,s to this jigsaw with the same bore,s ? which is which same motor,s diff stroke,s ?

 

Personally ? I think a sonic check would be in order for that C6ME block Just to see how much meat you have in the cylinder walls... It might be a good canidate for a larger bore?

Sonic Checks here in the US in my area are about $50..Very cheap insurance,,

Russ

 

hi all just did the drill bit test a 13/64 fit between the barrels inside doz this help ?been reading out post on 330ft s

 

would be happy with a 361

 

hi all just letting you all no it all rebuild and in the truck , sum change to what i planed , heads c8ae-h , edelbrook intake stock replacement one for 390,s truck cam, silvolite pistons = 40 th , over sized ( 3144d ) ,0 balnced 8.5 to 1 compress ,shot peed rods , ported a little 3.50 stoke i guessing now i think it will have about 250hp , 350 ft am i close to what it may have ? love to no if sumone could work it out for me just waiting for the right starter to come bye post