bleeding clutch
Junior User
Joined: Dec 2001
Posts: 79
Likes: 0
From: rio rancho USA
bleeding clutch
Yes. Get a 2000cc (very large) hypodermic syringe and 3 feet of 1/4 id hose and 1 buddy. block clutch pedal half way down.Remove hose from bottom of resevoire and aim into a container. Put the hose on the syringe and suck up a full syringe of brake fluid. Tip the whole rig hose end up vertical and purge the air(keep it like this until ready to use). Loosen bleeder valve and put hose on valve. Push fluid through the system and then lock the bleeder. put system hose back on resevoire and fill to line(leave open). Get in and pump the clutch to remove any air caught in master cylinder if needed. It took a while to get the air out of my master cylinder but this did work better than trying to do it like a brake system.
Senior User
Joined: Feb 2002
Posts: 113
Likes: 0
From: BAYVILLE
bleeding clutch
[updated:LAST EDITED ON 17-Nov-02 AT 09:51 AM (EST)]
do you need a special wrench to bleed
the cylender or somthing like a brack bleed wrench
can you tell me the size of the bleeder valve on the clutch
slave cyl
do you need a special wrench to bleedthe cylender or somthing like a brack bleed wrench
can you tell me the size of the bleeder valve on the clutch
slave cyl
Thread
Thread Starter
Forum
Replies
Last Post
L.TONY F350
1987 - 1996 F150 & Larger F-Series Trucks
6
Dec 23, 2009 08:53 PM
ekelly
Explorer, Sport Trac, Mountaineer & Aviator
3
Nov 11, 2003 02:42 PM
