shimmy and vibrates
Thread Starter
|
Senior User
Joined: Aug 2004
Posts: 104
Likes: 0
shimmy and vibrates
I have a 1986 bronco 2 4x4 and I love it,but it shimmys at 60-75 mph it sat for a couple years but now I need it for transportation,I put new tires and had them balanced on the front,and replaced the ball joints on the passenger side,I will replace them on the drivers side if I have to,but I'm low on funds and don't wanna make any unneccesary purchases,they seem tight,no wiggle like the side I replaced...anyone have any idea what else it could be???I had an alignment done before I put it away a couple years ago,but it still shimmied...could it be tie rod ends??I know the rear tires are out of round from sitting for so long(probably about 6 years) Any advice will be greatly appreciated
Last edited by dogg16; Aug 2, 2004 at 03:55 PM.
Freshman User
Joined: Jul 2004
Posts: 30
Likes: 0
I'm going with thetires too...sitting never really helps a tire. Overinflating them before an extended sit can help. At this point, check the tire pressures and then if you still have the problem, have them rebalanced.
BB
BB
Thread
Thread Starter
Forum
Replies
Last Post
rpm5099
Explorer, Sport Trac, Mountaineer & Aviator
1
Dec 23, 2008 01:22 PM
