order new gauges where?
Thread Starter
|
Junior User
Joined: May 2000
Posts: 85
Likes: 0
order new gauges where?
I want to get a few gauges like trans and ???? and ???? temperature gauges. I am going to tow a 10,000+ lb trailer with a 2000 psd automatic with 4.10 rear end. What gauges and where on the internet??
Richard
Richard
New User
Joined: Feb 2002
Posts: 1
Likes: 0
order new gauges where?
[updated:LAST EDITED ON 22-Feb-02 AT 10:40 PM (EST)]I just bought a full set of VDO Vision gauges and a full A-pillar gauge pod from http://www.egauges.com. I really like the VDO gauges and they were the best price I found. I paid $256 and change for the gauges, sender, boost gauge installation kit and the pod. That included shipping. Hope this helps.
Best regards,
Dave
'97 F250 SC, 4X4, 4:10's, Open Element Air Filter, Shimmed, 10k mod, E40D w/Hayden 679 Cooler, Magnefine (NAPA)Inline Filter, Sonnax Valve and Tricumulator Springs, Mobil 1 Synth. in tranny and transfer case, Redline Synth. 75W140 in rear diff., Mobil 1 Synth. 75W90 in front diff., still runnin' Rotella in the engine, Full A-Pillar w/VDO gauges, Coolant Filter w/John Deere Coolant Eye, Rhino Lined, Goodyear 265/75R16's on factory aluminum wheels, Westin Nerf Bars and Brush Guard, Mile Marker Hubs pulling a 27' 5th Wheel TT whenever I get time.
NRA Life Member
NProfanity RemovedSponsor Member
Best regards,
Dave
'97 F250 SC, 4X4, 4:10's, Open Element Air Filter, Shimmed, 10k mod, E40D w/Hayden 679 Cooler, Magnefine (NAPA)Inline Filter, Sonnax Valve and Tricumulator Springs, Mobil 1 Synth. in tranny and transfer case, Redline Synth. 75W140 in rear diff., Mobil 1 Synth. 75W90 in front diff., still runnin' Rotella in the engine, Full A-Pillar w/VDO gauges, Coolant Filter w/John Deere Coolant Eye, Rhino Lined, Goodyear 265/75R16's on factory aluminum wheels, Westin Nerf Bars and Brush Guard, Mile Marker Hubs pulling a 27' 5th Wheel TT whenever I get time.
NRA Life Member
NProfanity RemovedSponsor Member
Thread Starter
|
Junior User
Joined: May 2000
Posts: 85
Likes: 0
order new gauges where?
THANKS!!! Ken and Dave
I bought a full set of VDO Vision gauges and a full A-pillar gauge pod from http://www.egauges.com also. $265 includes shipping. Next is to get a chip mondule. For the load it shoild be the 54 HP but I would like to go higher. I need to find out the cost of an exhust system change....Richard
I bought a full set of VDO Vision gauges and a full A-pillar gauge pod from http://www.egauges.com also. $265 includes shipping. Next is to get a chip mondule. For the load it shoild be the 54 HP but I would like to go higher. I need to find out the cost of an exhust system change....Richard
Thread
Thread Starter
Forum
Replies
Last Post
