Two new error codes
Thread Starter
|
Tuned
Joined: Feb 2002
Posts: 441
Likes: 0
From: Vicksburg, MS
Two new error codes
I pulled the error codes yesterday, and this is what I got:
These two have been on there for a while-
327 - EVP or DPFE circuit below minimum voltage
328 - EGR closed voltage higher than expected
These two are new-
173 - HEGO shows system always rich
628 - Converter clutch error (E4OD)
The first three, I would like some advice about how to fix. The last one is rather obvious. I'm rather POed about the 628 because I just rebuilt my E40D back in April, and got a new TC. I knew the torque converter was bad then, but I never got any error codes on it. From day one, the new TC didn't feel right. Why would I get a code now, but not back when it was slipping and vibrating rather badly before I changed it?
Any help? Thanks.
These two have been on there for a while-
327 - EVP or DPFE circuit below minimum voltage
328 - EGR closed voltage higher than expected
These two are new-
173 - HEGO shows system always rich
628 - Converter clutch error (E4OD)
The first three, I would like some advice about how to fix. The last one is rather obvious. I'm rather POed about the 628 because I just rebuilt my E40D back in April, and got a new TC. I knew the torque converter was bad then, but I never got any error codes on it. From day one, the new TC didn't feel right. Why would I get a code now, but not back when it was slipping and vibrating rather badly before I changed it?
Any help? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
jlarr
Clutch, Transmission, Differential, Axle & Transfer Case
7
Jan 4, 2015 09:47 PM
HVJ
1987 - 1996 F150 & Larger F-Series Trucks
1
Jan 21, 2005 12:10 PM
