T98 instillation
Thread Starter
|
5th Wheeling
Joined: Dec 2023
Posts: 43
Likes: 1
From: Oklahoma City, Oklahoma
T98 instillation
I’m having the hardest time getting my t98 back in my 64’. It’s difficult to set upright on my transmission jack and it won’t fit. Has anyone had a similar hard time and do you have any tips? I’m between towing it to a lift or cutting a hole in the floor to help stabilize it as it’s lifted. Any help would be appreciated.
More Turbo
Joined: Nov 2019
Posts: 548
Likes: 74
From: Point Washington
Stabilizing transmission on a jack
I took a couple of pieces of 3/4” angle iron and bolted them to the tail shaft housing bolts and then to the chain arms on the trans jack. These held it rigidly to the support plate on my Harbor Freight trans jack.
That’s how I got the NP435 back into my 65.
Mine does have the full size hole in the cab floor, that helps a lot.
That’s how I got the NP435 back into my 65.
Mine does have the full size hole in the cab floor, that helps a lot.
Cargo Master
Joined: Jul 2015
Posts: 2,069
Likes: 139
From: tucson
If you haven't done this yet, get some longer replacement bolts for bolting the transmission to the bell housing. Cut the heads off and cut slots in the end. This is to help align the two, as they are brought together. Then replace with the correct bolts once things are aligned. I did this, by myself, on my '64.
Thread
Thread Starter
Forum
Replies
Last Post
