Greasing the bearings!!!
Thread Starter
|
New User
Joined: Sep 2003
Posts: 12
Likes: 0
Greasing the bearings!!!
Does anybody know how to grease the front end to a 99 Ford Ranger 4x4 XLT? My grease gun will not fit it. Do I have to lift my truck in any certain order to get it to fit or does this type of truck have those "NO LUB" needed front ends.
Thanks
Happy Holidays
jon
Thanks
Happy Holidays
jon
Senior User
Joined: Mar 2003
Posts: 282
Likes: 0
From: ontario
when my grease gun broke i took my wifes new van to a lube shop after the oil change i have done and asked for just a lube only and they said they cant do it because they are permenent from the factory . i would take the truck to the dealership to find out if they are ok to grease them or not.
New User
Joined: Aug 2003
Posts: 10
Likes: 0
From: MADISON
I have a '99 Ranger XLT and if you can find any grease zerks I'd like to know where because I can't find any. I believe they are all sealed but if I'm wrong let me know. I had to replace the factory tie rods on a '94 Ranger 2wd at 30K and the aftermarkets did have the grease fittings.
Thread Starter
|
New User
Joined: Sep 2003
Posts: 12
Likes: 0
Grease fittings
I believe I have grease fittings on my truck, but I cannot get the gun to fit over the fitting because the tie rods and A arm are in the way. I don't know if they are fittings or not because I can't get the stupid coupling to fit over them. Does anybody else have this problem?
jon
jon
Thread
Thread Starter
Forum
Replies
Last Post
