2010 Crank, no start.

Reply Subscribe

Thread Tools

Search this Thread

Sep 12, 2023 | 03:59 PM

snowdog79

Thread Starter

Laughing Gas

Joined: Mar 2006

Posts: 1,164

Likes: 2

From: Tri-Cities, TN

2010 Crank, no start.

5.4, fuse #27 is good - no sign of melting or anything on either the fuse or socket but I swapped fuse to be sure, replaced the fuel pump drive module. Any other ideas as to what the cause could be? Never given any trouble, parked it two days ago and now no start. I do not hear the pump when I turn the key on.
TIA

Sep 13, 2023 | 10:25 PM

steve(ill)

Hotshot

Joined: Jul 2005

Posts: 11,931

Likes: 180

pump does not run... No power to it ? If its not the fuse, maybe squirrels chewed on the wire, etc. I think the harness runs along the frame and there is a connector under the driver seat area for the front to rear harness... Look on you tube and see how to check voltage to that plug, and continuity from the plug to the rear harness to the pump.

Sep 13, 2023 | 10:27 PM

steve(ill)

Hotshot

Joined: Jul 2005

Posts: 11,931

Likes: 180

check to see that you have power at the wire OUT of the fuse... Remember, it only runs for 3 seconds when you turn the key ON... after that there is no power until you cycle the key off- ON again.