V10 Airbox Mod

Reply Subscribe

Thread Tools

Search this Thread

Aug 14, 2023 | 12:03 PM

Smoothwater

Thread Starter

Mountain Pass

Joined: Jan 2021

Posts: 235

Likes: 56

From: St. Petersburg, FL

V10 Airbox Mod

Was doing some PM on the Ex this weekend. Cleaned the MAF and new air filter.

Ended up cutting the 2" snout off the air box and running 4” silicone tubing through the the factory location after i opened up the mounting plate with a grinder. IAT look good give this a try and see how it runs.

Aug 14, 2023 | 01:38 PM

MasterX

MUST GO FASTER!!!!

Joined: Aug 2020

Posts: 1,538

Likes: 356

From: Arizona

ive considered doing this several times, after you cut the snout off the airbox, how did you attack the silicone tube??

Aug 15, 2023 | 07:50 AM

Smoothwater

Thread Starter

Mountain Pass

Joined: Jan 2021

Posts: 235

Likes: 56

From: St. Petersburg, FL

All press fit for now. Going to see how it does. May fab up a 4" velocity stack into the bracket and clmap on the silicone coupler.

Aug 18, 2023 | 03:33 PM

DoOver

Cross-Country

Joined: Sep 2008

Posts: 97

Likes: 22

From: Catskill Mountains Of NY

Any report?

Aug 21, 2023 | 08:56 AM

Smoothwater

Thread Starter

Mountain Pass

Joined: Jan 2021

Posts: 235

Likes: 56

From: St. Petersburg, FL

No problems so far IAT look close to ambient. Drove it our lake place and back with the boat and did well.

Havent had a chance to look at MAF reading to see if it picked up any lb/min.

Aug 22, 2023 | 04:26 PM

MasterX

MUST GO FASTER!!!!

Joined: Aug 2020

Posts: 1,538

Likes: 356

From: Arizona

i would think the IAT impact at speed would be fine, but the IAT sitting still would be the one to watch.

Mine runs a little warm when sitting still if its allowed to sit running for 20+ minutes, but as long as your not doing that the temps are fine.