E4od pressure
Thread Starter
|
Freshman User
Joined: Dec 2020
Posts: 34
Likes: 0
E4od pressure
91 e4od, did pressure test at the port once at operating temp and in all selections park through 1st it read in between 80-90psi. Is that normal, I thought there would be more variety to that
also tc isn’t locking up
also tc isn’t locking up
Frmr Ford Trans Engr
Joined: Aug 1999
Posts: 24,725
Likes: 2,651
From: SE Florida
Park, neutral, drive, and 2 should be between 50 and 65 PSI at idle. At stall, drive and 2 should be between 165 and 185 PSI.
Reverse and 1 should be 70-100 PSI. At stall, reverse should be 245-290 PSI. 1 should be 175-210 PSI at stall.
Stall is when the trans is in gear, your left foot HARD on the brake, and your right foot planting the go pedal on the floor. CAUTION: DO NOT HOLD STALL FOR MORE THAN 5 (FIVE) SECONDS AT A TIME!! IDLE OR FAST IDLE FOR AT LEAST 30 SECONDS BETWEEN STALL TESTS.
Reverse and 1 should be 70-100 PSI. At stall, reverse should be 245-290 PSI. 1 should be 175-210 PSI at stall.
Stall is when the trans is in gear, your left foot HARD on the brake, and your right foot planting the go pedal on the floor. CAUTION: DO NOT HOLD STALL FOR MORE THAN 5 (FIVE) SECONDS AT A TIME!! IDLE OR FAST IDLE FOR AT LEAST 30 SECONDS BETWEEN STALL TESTS.
Thread
Thread Starter
Forum
Replies
Last Post
RRE101
Clutch, Transmission, Differential, Axle & Transfer Case
1
Jun 14, 2010 07:57 PM
brownbronco
Clutch, Transmission, Differential, Axle & Transfer Case
2
Nov 18, 2008 07:03 PM
javi2001
Clutch, Transmission, Differential, Axle & Transfer Case
9
Jul 14, 2005 07:45 PM
Clipper508
Clutch, Transmission, Differential, Axle & Transfer Case
1
Jan 21, 2003 06:40 AM
