Steering box
Thread Starter
|
5th Wheeling
Joined: May 2021
Posts: 25
Likes: 1
Steering box
I have a 1968 f100 2wd manual steering. I unbolted the steering box from the frame in order to run new fuel lines behind it. Now I can’t get it back in to position to bolt back up. I’m looking for some advice on the best way to tackle this. Do I need to disconnect the steering column or the pitman arm in order to get it bolted back into position?
thanks.
thanks.
Cargo Master
Joined: Oct 2011
Posts: 2,251
Likes: 304
From: Kenner,La.
Are your rubber body mounts and brackets on the body in good condition? Are they rusted badly and collapsed? If so you better take care of that before you go any further. If all of that is good. Try un bolting the steering column then bolt the steering box in place, after that you should be able to mate the rag joint to the steering column.
Thread
Thread Starter
Forum
Replies
Last Post
LITTLE BLACK TRUCK
1973 - 1979 F-100 & Larger F-Series Trucks
12
Dec 6, 2012 11:54 PM
