Part #/source request

Reply Subscribe

Thread Tools

Search this Thread

Jul 23, 2021 | 04:38 PM

#31

Walleye Hunter

Hotshot

Joined: Mar 2014

Posts: 10,750

Likes: 1,065

From: Douglassville, PA

Quote:

Originally Posted by Sous

I am once again humbled by the generosity and kindness this community puts forward each and ev every day.

Thanks again Mark. I look forward to thanking you in person one day at a PA GTG or when we pass through again.

Oh man, I could have cleaned that up better!

Jul 24, 2021 | 05:47 AM

#32

FordTruckNoob

FTE Chapter Leader

Joined: Jan 2005

Posts: 13,122

Likes: 4,725

From: Henderson, NV

Quote:

Originally Posted by Sous

3D scan that sucker you can print future copies.

Jul 24, 2021 | 06:56 AM

#33

Sous

Thread Starter

FTE Leadership Emeritus

Joined: May 2014

Posts: 27,354

Likes: 5,946

From: Lake Hartwell, GA

Quote:

Originally Posted by Walleye Hunter

Oh man, I could have cleaned that up better!

It is perfect just the way it is. I assure you it will look great once installed and do a good job of keeping the jack extension arm off the upper radiator hose.

Thanks again Mark.

Quote:

Originally Posted by FordTruckNoob

3D scan that sucker you can print future copies.

I have a 3D printed IPR wrench I bought from an FTE'r several years ago. Other than that, i wouldn't know where to start with 3D printing or scanning.

Jul 24, 2021 | 07:39 AM

#34

FordTruckNoob

FTE Chapter Leader

Joined: Jan 2005

Posts: 13,122

Likes: 4,725

From: Henderson, NV

Quote:

Originally Posted by Sous

I have a 3D printed IPR wrench I bought from an FTE'r several years ago. Other than that, i wouldn't know where to start with 3D printing or scanning.

Buy one of these scanners then send the file off to this 3D printing marketplace.