When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 1971 F250 CS that I am replacing the steering gearbox on. I have the old gearbox out and am trying to get the pitman arm off of it. I rented a pitman arm puller from Autozone, but the fingers are too thick to get between the arm and the gearbox. Has anyone tried a different puller that can fit in the gap (it's roughly 1/8") and where I could find it?
While back had the same problem. Just bought the puller from autozone then hit it with the grinder. Another time had to remove the steering box and have it pressed off. Just rember to be gentle with the box if your reusing it.
Yup, buy and grind. I got mine from Harbor Freight. I measured the gap between the box and the top of the arm with feeler gauges; on my truck it was about 0.160". I then painted some prussian blue on the arm fingers, scribed a line on the puller where it needed to be ground with some calipers and went at it with a grinder. Slid right into the gap and pulled the arm off without a hitch.
Rezvani's Latest Post-Apocalyptic Monster Is a Ford F-150 Raptor Underneath
Slideshow: Called the Fortress, the 850-horsepower pickup combines Raptor underpinnings with military-inspired features, survival equipment, and a starting price of $285,000.
