E40D Reinstall, Engine Wont Turn WTF Did I Do/Please Help
It was indeed not fully seated. I pulled the TC inspected the rear hub and looked close deep into the pump. No signs of any damage at all.
A little messing around and I got it seated deep into the bell housing. It was back a quarter inch ish back from the face of the bell housing. It turned and rotated smoothly.
All reassembled now.
After doing this job once, it is really not that hard to pull the transmission off these. Surprisingly easy job honestly.
Even on jack stands on garage floor with a creeper jack with a 12 x 12 pad adapter and a heavy duty cargo strap. Very simple.
The hardest part was taking apart the oil pump and pickup tube and getting the new pan seal in working around it on reinstall to be honest.
Thanks again for the help guys, honestly. Greatly appreciated!






