When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm adding a hydraulic clutch setup to my vehicle and am using a slave cylinder from a 1966 P 350... can anyone tell me the line fitting thread size going into this slave cylinder? Coming from the master it's a standard 3/16ths line and fitting, but on the back of the slave it's larger. I'd love to just bring it to NAPA and try different sizes, but it's a bit stuck in place now... don't ask.
