Just picked this up in Cali
#2
Nice find!
I'm guessing that bed came off a pre-70 truck since the bump goes all the way to the end of the bed. No side reflectors at all like a 67, but obviously something whoever had it before might have changed.
Are the rear reflectors under the tail lights recessed into the bed? Never seen any that looked like that. Looks a lot cleaner than the original.
I'm guessing that bed came off a pre-70 truck since the bump goes all the way to the end of the bed. No side reflectors at all like a 67, but obviously something whoever had it before might have changed.
Are the rear reflectors under the tail lights recessed into the bed? Never seen any that looked like that. Looks a lot cleaner than the original.
#3
Nice find!
I'm guessing that bed came off a pre-70 truck since the bump goes all the way to the end of the bed. No side reflectors at all like a 67, but obviously something whoever had it before might have changed.
Are the rear reflectors under the tail lights recessed into the bed? Never seen any that looked like that. Looks a lot cleaner than the original.
I'm guessing that bed came off a pre-70 truck since the bump goes all the way to the end of the bed. No side reflectors at all like a 67, but obviously something whoever had it before might have changed.
Are the rear reflectors under the tail lights recessed into the bed? Never seen any that looked like that. Looks a lot cleaner than the original.
I like the shade of blue!
#5
#6
#7
Engine and bumper and bed
To chirkware; the bed was modified deleting the reflectors and yes in back are dot type reflector stickers.
FuzzFace2; the engine and trans are out of a 92 F150 302 efi and E40D. The diff is out of the same truck 8.8/3:73 ratio. Peg leg.
lilorbie; the front bumper was shortened 4" with the center plate indentation removed. I have plans to finish the metal work and chrome.
Trending Topics
#8
I modified my front & rear bumpers on my 81 F100 Flareside but don't have the $$ to get them chromed so going to look into getting them wrapped in Chrome. If they can't be wrapped then I will have to pick a color and paint then.
I did have an air filter lid powder coated chrome. It's ok for what I was looking for, unpolished chrome, but it is no way near chrome plating.
Other than being tuff it looks a little better than silver spray paint.
My .02
Dave - - - -
I did have an air filter lid powder coated chrome. It's ok for what I was looking for, unpolished chrome, but it is no way near chrome plating.
Other than being tuff it looks a little better than silver spray paint.
My .02
Dave - - - -
Thread
Thread Starter
Forum
Replies
Last Post
37 Ford guy
1961 - 1966 F-100 & Larger F-Series Trucks
9
11-23-2011 07:37 PM
65fordguy
1961 - 1966 F-100 & Larger F-Series Trucks
10
11-12-2009 12:26 AM