ZF6 Bellhousing - CAD Drawing?
#1
07-15-2018, 04:25 PM
ZF6 Bellhousing - CAD Drawing?
Does anyone have a CAD drawing (preferably DXF file) for a 6.0 ZF6 bellhousing pattern? Also the distance from the flywheel clutch surface to the the bellhousing bolt surface on the engine?
Starting the engine swap into my 2006 F350 and will have to have a custom adapter plate and flywheel cut out to mate my ZF6 to the 6068 Deere that I just picked up...
Starting the engine swap into my 2006 F350 and will have to have a custom adapter plate and flywheel cut out to mate my ZF6 to the 6068 Deere that I just picked up...
#2
06-25-2019, 03:56 PM
Does anyone have a CAD drawing (preferably DXF file) for a 6.0 ZF6 bellhousing pattern? Also the distance from the flywheel clutch surface to the the bellhousing bolt surface on the engine?
Starting the engine swap into my 2006 F350 and will have to have a custom adapter plate and flywheel cut out to mate my ZF6 to the 6068 Deere that I just picked up...
Starting the engine swap into my 2006 F350 and will have to have a custom adapter plate and flywheel cut out to mate my ZF6 to the 6068 Deere that I just picked up...
Thread
Thread Starter
Forum
Replies
Last Post
rangerottis
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
1
05-23-2014 03:57 PM
1FastGambler
1973 - 1979 F-100 & Larger F-Series Trucks
2
06-20-2011 04:15 PM
Bill Hanson
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
7
01-02-2006 08:35 PM
Mid_Mo_F100
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
12-16-2005 08:32 PM