Checking injector wiring?
Thread Starter
|
Senior User
Joined: Mar 2003
Posts: 202
Likes: 0
From: south jersey
Checking injector wiring?
Im getting codes P0275 and P0273. I ohmed out the pins on #5 injector and they were fine. Could you guys tell me how to check the plug and harness? And the easiest way to remove the plug from the ficm? Any other advice on what to look for while Im under the hood? Ive noticed a decline in mpg and it idles noticeably worse and when in OD at a slow speed it shakes a little. 2007 6.0 BTW
Postmaster
Joined: Sep 2016
Posts: 3,941
Likes: 240
From: Texas
Unbolt the FICM from the bracket and squeeze both sides of each comnector, push in and gently but firmly rock the FICM as you pull. They are tight but be gentle because if they are old the connectors get brittle from heat.
You can get with a shop or person with the software to perform a click tesft or buzz test on the injectors. Call ficmrepair.com and discuss further with Ed or Scott, they can get you set up.
You can get with a shop or person with the software to perform a click tesft or buzz test on the injectors. Call ficmrepair.com and discuss further with Ed or Scott, they can get you set up.
Postmaster
Joined: Sep 2016
Posts: 3,941
Likes: 240
From: Texas
Thread
Thread Starter
Forum
Replies
Last Post
eric777
1999 - 2003 7.3L Power Stroke Diesel
2
Sep 8, 2006 12:24 PM
