installing dash cam
Thread Starter
|
Junior User
Joined: Jun 2008
Posts: 87
Likes: 2
From: AZ in Winter UT in Summer
installing dash cam
I am installing a dash cam in my 2011 f-250 super duty XL. I want to run the wire for the dash cam from the center top of the windshield under the front of the headliner to the drivers windshield side post and down to under the dash where I will hook into power for the dash cam. I want the wires hidden. But am unsure as to how to remove the trim on the Drivers side windshield post. I know that the hand hold has to be removed, but what else to get the trim piece off of the post. any help or advice appreciated.
Mel
Mel
Posting Guru
Joined: Sep 2013
Posts: 1,348
Likes: 6
From: Edmonton, AB
pop out the two caps that are on the handle cover, under those two caps are two screws, undo the two screws and pull on the handle. It's just clips holding
that A pillar piece on after the two screws are removed
that A pillar piece on after the two screws are removed
Thread Starter
|
Junior User
Joined: Jun 2008
Posts: 87
Likes: 2
From: AZ in Winter UT in Summer
Thread
Thread Starter
Forum
Replies
Last Post
SpringerPop
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
6
May 19, 2013 06:44 AM
