Some one at that factory or after was not paying attention during the install . Maybe they should have have put little notches on the out side grille dagmars to designate which went where just like the rear & front ribbed bumpers on a '51 or '52 . Now every one who owns these yrs. will run out & check asap !

 

jmadsen,maybe the reason for those teeth facing out at an angle is that someone put the left one in the right location and the right one in the left location.just a thought,but i know that each one has its own location.

 

My 51 is bolted on. The truck was assembled in the Norfolk Va, plant.