Rusty crust in distrubutor bore
Thread Starter
|
Tuned
Joined: May 2007
Posts: 429
Likes: 2
Rusty crust in distrubutor bore
The block was steam clean, vatted. I see the bore for the distributor has some rusty crust in it this raised surface up making the bore smaller.
Best way to get rid of this without boring it? And keep the bore accurate.
Can't be scrapped out.
Best way to get rid of this without boring it? And keep the bore accurate.
Can't be scrapped out.
Super Moderator
Joined: Apr 2004
Posts: 34,495
Likes: 2,809
Wire "bottle brush".
https://www.solobrushes.com/Products...FVKewAod1s8D6Q
Should have been done when the block was cleaned.
https://www.solobrushes.com/Products...FVKewAod1s8D6Q
Should have been done when the block was cleaned.
Ford Parts Specialist
Joined: Nov 2006
Posts: 88,826
Likes: 785
From: Simi Valley, CA
Wire "bottle brush".
https://www.solobrushes.com/Products...FVKewAod1s8D6Q
Should have been done when the block was cleaned.
https://www.solobrushes.com/Products...FVKewAod1s8D6Q
Should have been done when the block was cleaned.
Thread
Thread Starter
Forum
Replies
Last Post
jkidd_39
1999 - 2003 7.3L Power Stroke Diesel
1
Sep 5, 2010 09:29 AM
mswift
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
5
May 31, 2007 01:34 PM
Ratsmoker
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
3
May 13, 2002 10:43 AM
