Tranny probs
Thread Starter
|
New User
Joined: Jan 2017
Posts: 3
Likes: 0
Tranny probs
So I have a 09 6.4 and I started having tranny probs with it getting hung in between 3&4 so I replaced solenoid d and still did it so I put my sct programmer to stock and still did it. I finally went and got my tcm reflashed about a week after I replaced the solenoid and it still does it I even bought a new programmer bc I read my programmer could be the problem and still doing it. Now it shift 1-3 fine and hung up in 3 going to 4 and 5-6 fun but after I stop I go straight into 4th and then my wrench light comes on and I **** perfect 1-4 but that's all the gears I have. What could be making my truck do this? And btw I have the dpf deleted and k&n air intake and a bully dog gt platinum programmer. Any help would be great thanks
Thread Starter
|
New User
Joined: Jan 2017
Posts: 3
Likes: 0
Yes it shifts 1-3 fine but going into 4th it gets hung up and then goes through the rear gears fine but when I stop it goes straight to 4th and when I start to go it throws the wrench on the dash and goes back to 1st and shifts fine until I get to 4th and that's all I got it want go into 5th
Frmr Ford Trans Engr
Joined: Aug 1999
Posts: 24,739
Likes: 2,669
From: SE Florida
I don't know what the rear gears are. I've never heard of those.
The first thing to do is to get the codes read. The places that read codes free CANNOT read the codes that you need. Go to a good independent shop or a Ford dealer.
The first thing to do is to get the codes read. The places that read codes free CANNOT read the codes that you need. Go to a good independent shop or a Ford dealer.
Thread
Thread Starter
Forum
Replies
Last Post
