Electrical dummy question
Thread Starter
|
Laughing Gas
Joined: Aug 2010
Posts: 983
Likes: 49
From: Northern Kentucky
Electrical dummy question
First off, I admit to being an electrical dummy. That said, I am about to wire in a Dura-Spark ignition into my '89 F-250 using instructions that Franklin2 posted in an earlier thread.
Most of the wires involved (module etc.) look like 16 gauge wires. My supply of 16 gauge wire is limited but I have a very good supply of 12 gauge gas and oil resistant wire. I know its dangerous to use smaller than necessary wires but is there a down side to going to somewhat larger wire? Would I be OK using the 12 gauge wire for this?
Any advice greatly appreciated.
Most of the wires involved (module etc.) look like 16 gauge wires. My supply of 16 gauge wire is limited but I have a very good supply of 12 gauge gas and oil resistant wire. I know its dangerous to use smaller than necessary wires but is there a down side to going to somewhat larger wire? Would I be OK using the 12 gauge wire for this?
Any advice greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
emgee
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
5
Mar 31, 2016 06:17 PM
Tyler S
1948 - 1956 F1, F100 & Larger F-Series Trucks
6
May 10, 2014 08:40 PM
iwanaflattie
1948 - 1956 F1, F100 & Larger F-Series Trucks
19
Dec 3, 2010 06:45 PM
