NEED HELP
Thread Starter
|
New User
Joined: Feb 2014
Posts: 5
Likes: 0
NEED HELP
I have a 94 f250 4x4 ext. cab 8 foot bed with the Dana 50 4600 front axle. My original wheel hub on my passenger side was junk so I bought another one. Now my problem is it doesn't sit right on my spindle it woobles. The bearing and race are to far back. Leaves a gap between bearing and wheel seal. Farther looking in to it. I see it does not match my driver side. Bought another one same problem. I'm not lost on all this. They both came off 90s Dana 50s. Even tried a Dana 60 hub no good. Can anyone shed some light on this?? Can't get my pictures to appear on here. I can email them if needed. Thanks
Cargo Master
Joined: Nov 2013
Posts: 2,168
Likes: 3
From: South Central,MO
You say it wobbles. Are the bearings tight against their races or are they not seating on the race?
I think there is supposed to be a slight gap between the inner bearing and the lip of the seal.
Is it possible the original junk hub has damaged the spindle?
I think there is supposed to be a slight gap between the inner bearing and the lip of the seal.
Is it possible the original junk hub has damaged the spindle?
Cargo Master
Joined: Nov 2013
Posts: 2,168
Likes: 3
From: South Central,MO
Extended cabs all came with D50's and I think the mounting for a D44 is different, but still, anything is possible. D50 and D60 hubs are the same hub so there is definitely something funky going on here.
Thread
Thread Starter
Forum
Replies
Last Post
7.3johnny
1987 - 1996 F150 & Larger F-Series Trucks
0
Jul 16, 2019 07:11 AM
Thomscottson
1987 - 1996 F150 & Larger F-Series Trucks
18
Mar 30, 2018 07:03 AM
akparker1
1973 - 1979 F-100 & Larger F-Series Trucks
4
Feb 12, 2009 10:23 PM
fairlaniac
Clutch, Transmission, Differential, Axle & Transfer Case
1
Oct 26, 2006 11:10 AM
