Keyless Entry Programming Help
Thread Starter
|
Senior User
Joined: Feb 2003
Posts: 166
Likes: 0
From: Pennsylvania
Keyless Entry Programming Help
Hey everyone, I have a 1996 F150 with the factory keyless, an my one and only remote got wet & went bad. Just got a new one in the mail today, and I was hoping someone could help me reprogram it. I've looked into other forums about turning the key on and off method (didn't work), as well as jumping the two connectors and putting it into programming mode, but I think my module is a little different than the ones that I've seen in forums, as I can't find the little gray connector that I'm supposed to "jump" to go into programming mode.
Here's a link to a pic of the module: F150 Keyless Module - Imgur
There are no factory serial/model numbers or identifiable markings on the module.
Could anyone recognizes this module and point me in the right direction to where the little jumper connector I'm supposed to use? Offer any help?
Many thanks!
Here's a link to a pic of the module: F150 Keyless Module - Imgur
There are no factory serial/model numbers or identifiable markings on the module.
Could anyone recognizes this module and point me in the right direction to where the little jumper connector I'm supposed to use? Offer any help?
Many thanks!
Thread
Thread Starter
Forum
Replies
Last Post
