Crankshaft position sensor
Thread Starter
|
Freshman User
Joined: Apr 2003
Posts: 44
Likes: 0
Crankshaft position sensor
Hey guys, I replaced the crankshaft position sensor on my 97 ranger, ran fine, then check engine light came on again, this time the scanner says camshaft position sensor. Any ideas? Anyone have this problem before, I believe the mechanic said code P0304...thanks
Post Fiend
Joined: Jan 2003
Posts: 9,748
Likes: 16
From: Connecticut
Crankshaft position sensor
P0304 is a cylinder # 4 misfire.
Your crankshaft position sensor and your camshaft position sensor are both used to detect engine misfire and identify the cylinder where it occured.
Try finding your code here (click the OBDII Codes link) and see what possible causes are listed:
Technical Info Sticky
Your crankshaft position sensor and your camshaft position sensor are both used to detect engine misfire and identify the cylinder where it occured.
Try finding your code here (click the OBDII Codes link) and see what possible causes are listed:
Technical Info Sticky
Last edited by Rockledge; Jun 17, 2003 at 10:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post
okla82bronco
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
6
Jul 30, 2017 05:33 AM
guntherh_3
1997 - 2006 Expedition & Navigator
12
Mar 11, 2016 01:10 PM
RixWorx
1983 - 2012 Ranger & B-Series
4
Dec 30, 2015 04:31 PM
