AutoEnginuity and etest
Thread Starter
|
Senior User
Joined: Oct 2006
Posts: 210
Likes: 2
From: Welland, On
AutoEnginuity and etest
My truck is up for an etest (I live in Ontario) and I was wondering if I can use my AE to check to see if my 6.0 would pass before I bring it in? Of course my next question is how would I do it? What system would I use? What DTCs would pertain to the etest? Or is my OBD system not yet fitted with this technology? Thanks
Certified Thread Hijacker
Joined: Aug 2001
Posts: 14,441
Likes: 60
Monitor Readiness Test... it checks the sensors and reports 11 reported values.
Some of which do not pertain to the 6.0. Most important likely is the EGR system.
The values will show "Ready", "Not Ready" or N/A.
You are usually allowed 1 and sometimes 2 statuses "Not Ready"
Josh
Josh
Some of which do not pertain to the 6.0. Most important likely is the EGR system.
The values will show "Ready", "Not Ready" or N/A.
You are usually allowed 1 and sometimes 2 statuses "Not Ready"
Josh
Josh
Thread
Thread Starter
Forum
Replies
Last Post
