Front wheel Bearings
Thread Starter
|
Mountain Pass
Joined: Jan 2012
Posts: 177
Likes: 0
Front wheel Bearings
I need to replace the passenger wheel bearing. My question is whether I have to dissemble the manual hub or if it can be removed in one piece. Also should both be replaced at once
97 F-250 Heavy Duty
97 F-250 Heavy Duty
Hotshot
Joined: Jan 2012
Posts: 11,132
Likes: 3
From: Southern West Virginia
The hub comes out in two pieces. Take the screws out of the outer part, and it just slides out. Then for the inner part there is a large snap ring around the perimeter that has to come out to get the inner half of the hub out. After you remove the snap ring, take two of the screws from the outer part and thread them back in the holes in the inner part for something to get a hold of to pull the inner half out. I would go ahead and do bearings on both sides while you're doing it.
Thread
Thread Starter
Forum
Replies
Last Post
davehaynes
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
4
Aug 2, 2011 03:43 PM
