Pinion Set-up Sterling 10 1/4 Rear
#1
Pinion Set-up Sterling 10 1/4 Rear
Replaced the pinion seal on my 92 IDI f350. A bear to get the yoke off. Used a system of c clamps and sockets.... OK, now setting it back up how do I adjust the tension on the nut that holds the yoke? Torque setting? Pre-load measurement (hope not). Anyhow I'd like to go for a drive so if anyone knows, let me know asap. Thanks so much GB
Thread
Thread Starter
Forum
Replies
Last Post
nddragon01
2004 - 2008 F150
11
03-31-2024 08:03 PM
Jeremy Kamutzki
1973 - 1979 F-100 & Larger F-Series Trucks
7
04-30-2014 06:33 PM
PM15106
1983 - 2012 Ranger & B-Series
1
11-21-2009 09:00 PM
vancouverpower
1999 - 2003 7.3L Power Stroke Diesel
8
04-04-2006 09:39 PM