EBP sensor
Thread Starter
|
Tuned
Joined: Sep 2011
Posts: 348
Likes: 1
From: Owensboro, KY
EBP sensor
I am getting a high reading(200's) on my ScanguageII for the EBP. The SGII x-guage forumla has been checked, so thats not the problem that I can tell.
My question is, If the sensor is bad does it give a DTC with the SES light?
Secondly, if I puncutured it when I cleaned it, would it have a low or no reading?
My question is, If the sensor is bad does it give a DTC with the SES light?
Secondly, if I puncutured it when I cleaned it, would it have a low or no reading?
Elder User
Joined: Jun 2007
Posts: 705
Likes: 1
From: Sandia Park, NM
I never got an SES when mine went out. I can't remember what troubleshooting I did but I plotted EBP against something. RPMs maybe? What I saw was a flat reading from the EBP. IIRC it should go up when RPMs go up. I did get a soft code stored for it that went away after replacement.
Posting Guru
Joined: Jun 2002
Posts: 1,028
Likes: 0
From: Panama City, Fl
Mine went out....truck ran like crap for about 20 mins. and died...never to start until the harness was unplugged . No lights. Scanner had issues communicating but finally showed a bad reading. Ran a week with it disconnected until getting a new one....$92 out the door at the local dealer.
Super Moderator
Joined: May 2004
Posts: 29,380
Likes: 118
From: Central Coast of CA
Ran without a sensor for over a year in my old truck. Just replaced it last night.
Stewart
Stewart
Thread
Thread Starter
Forum
Replies
Last Post
TNT in Round Rock
1999 - 2003 7.3L Power Stroke Diesel
5
Jan 24, 2012 03:58 PM
