New codes using AE
Thread Starter
|
Senior User
Joined: Aug 2011
Posts: 324
Likes: 0
From: NC
New codes using AE
Well since I got my AE running I used it get more information for my surging from https://www.ford-trucks.com/forums/1...y-surging.html
The first thing the AE checked was any codes, I usually check all the codes from all the sensors to see if anything can be a issue later on.
The report showed
U1262 SCP (J1850) Communication Bus Fault
C1284 Oil Pressure Switch Failure
P1812 4-Wheel Drive Mode Select Circuit Failure
I had cleared my codes from the P0470 this morning so right now only around 16 miles since reset, should I drive some more to see if some of the codes will clear them self.
If they don't reset themselves what would everyone's opinion on fixing these codes.
The first thing the AE checked was any codes, I usually check all the codes from all the sensors to see if anything can be a issue later on.
The report showed
U1262 SCP (J1850) Communication Bus Fault
C1284 Oil Pressure Switch Failure
P1812 4-Wheel Drive Mode Select Circuit Failure
I had cleared my codes from the P0470 this morning so right now only around 16 miles since reset, should I drive some more to see if some of the codes will clear them self.
If they don't reset themselves what would everyone's opinion on fixing these codes.
Thread
Thread Starter
Forum
Replies
Last Post
