Low brake fluid sensor
Thread Starter
|
Senior User
Joined: Jan 2012
Posts: 136
Likes: 0
From: Houston
Low brake fluid sensor
I installed a master cylinder from a 1988 Bronco II on my 1965 Ford. Worked out okay and now I would like to wire the fluid level sensor to a warning light in the cabin. I see though that it takes a three spade connector. Assuming I can find the connector, which wires should I use to light the light when fluid is low?
Thanks
Puttster
Thanks
Puttster
Lead Driver
Joined: Sep 2002
Posts: 9,182
Likes: 12
From: Gateway to the West
If the MC is out of a "deuce" (Bronco II) you might want to post this in the Ranger forum. The Bronco II was an entirely different model from the Bronco and based on the Ranger platform rather than the F-Series platform that the full-size Bronco derived from.
Thread Starter
|
Senior User
Joined: Jan 2012
Posts: 136
Likes: 0
From: Houston
Yes it is, thanks!
Thread
Thread Starter
Forum
Replies
Last Post
