Old Pecan Tree Shaker with Ford 390 - Wiring
#1
Old Pecan Tree Shaker with Ford 390 - Wiring
Hey Everyone,
I am updating an old pecan tree shaker that has an old Ford 390 motor. My question is on the wiring configuration. Currently this is the way it's setup:
1. #10 wire from ignition (IGN) >ballast resistor > + terminal on coil.(- terminal on coil > distributor).
2. #10 wire from ignition (BAT) > to main post on solenoid.
3. #16 wire from ignition (SOL) > "s" solenoid.
4. #10 wire from alternator > battery.
5. #10 wire from other main post on solenoid to the starter.
6. #4 battery cable from battery to one main post on solenoid.
7. #4 battery cable from other main post on solenoid to starter
Is this correct?? I will attach a drawing.
I am updating an old pecan tree shaker that has an old Ford 390 motor. My question is on the wiring configuration. Currently this is the way it's setup:
1. #10 wire from ignition (IGN) >ballast resistor > + terminal on coil.(- terminal on coil > distributor).
2. #10 wire from ignition (BAT) > to main post on solenoid.
3. #16 wire from ignition (SOL) > "s" solenoid.
4. #10 wire from alternator > battery.
5. #10 wire from other main post on solenoid to the starter.
6. #4 battery cable from battery to one main post on solenoid.
7. #4 battery cable from other main post on solenoid to starter
Is this correct?? I will attach a drawing.
Last edited by bpf; 12-13-2016 at 01:02 PM. Reason: attaching image
Thread
Thread Starter
Forum
Replies
Last Post
Julies Cool F1
1948 - 1956 F1, F100 & Larger F-Series Trucks
16
06-19-2010 03:42 AM
sainty333
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
5
10-20-2009 04:45 PM
justinfown1
1961 - 1966 F-100 & Larger F-Series Trucks
8
08-24-2008 08:52 PM
a BigR HamR
1948 - 1956 F1, F100 & Larger F-Series Trucks
6
07-01-2008 07:28 PM