Hey everyone, I have been reading tons of info on this forum about the 6.0 and I am well aware of all the issues but with that being said I am going to look at a 2005 F350 CC LB 6.0 truck tomorrow evening. I went to auto zone earlier and bought a scan gauge 2 to take with me. My question is, do i just plug this thing in and it will read out the coolant and oil temps or what? I have never used one before, mainly just wanting to use it to check the ECT/EOT delta. Basically I just need to know what to do once i plug it in to get where i need to be. Thanks

 

To read coolant temp it is preprogrammed so plug and play (FWT)

to read oil temp you need to set up a xguage (custom game) so need 5 minutes setup....

Guage: Engine Oil Temp (EOT)
TXD: 07E0221310
RXF: 046205130610
RXD: 3010
MTH: 00090005F060

basically you are instructing the scan guage to read a PID on the OB2 port from the truck.

 

You can use any obd2 port to set every thing up, and it will all stay for your use tomorrow.

 

Yes SIR^^^^Sean is right on the MONEY

Program and have ready to plug in for test ride

Oh and the ECT should be close to ambeint or under so if they warmed it up Before you got there they could be trying to hide a Bad FICM or something

 

Benny, give him a good short list of other xgauges to check. I am not where I can.

 

fWT on the ScanGaugeII is ECT its preprogrammed


EOT 07E0221310 046245130610 3010 00090005F05F

FLP 07E02209EF 0462450906CF 3010 006401000000 FICM Logic Power (Volts). Should be 12
Key On = 12.0
Low Idle = 13.5
High Idle = 13.5

Operating Range = 10.5‐15.5

FMP 07E02209D0 0462450906D0 3010 006401000000
48volts optimal all times check right at start

ICP 07E0221446 046205140646 3010 003900640000 Injector Control Pressure (PSI)
Key On = 0
Low Idle = 625.5

High Idle = 1400

‐1450
Operating Range = 0‐4045

IPR% 07E0221434 046285140634 3008 0DCA03E8000A IPR Duty Cycle (%)

Key On = 14.84

Low Idle = 24

High Idle = 40.60

Operating Range = 0

‐50

TFT 07E1221674 046205160674 3010 000100080000 Transmission Fluid Temperature (*F)

EBP

Exhaust Back Pressure

TXD: 07E0221445

RXF: 046285140645

RXD: 3010

MTH: 001D00500000

NAM:

EBP

Scangauge II Xgauge entering - YouTube

 

Ok thanks guys, appreciate the help. Im getting ready to go out and try to program it here in a few minutes on my current truck and see what happens. At the moment im driving a gm full size gas truck but im going to give it a try.

 

Can program the SGII on any 1996 OBDII or newer auto

The Xgauges will only work on a 6.0L but any auto to program