random
Thread Starter
|
Mountain Pass
Joined: Oct 2011
Posts: 106
Likes: 0
random
so i am now convinced that the previous owner of my truck was a complete *******. after having to deal with his wiring issues he caused when he put in the gauge cluster i found a edge performance chip under my passenger side battery that was plugged into my icp i believe. the model number on the chip was 10200 and all i can find on it is that its for the 7.3l. i have a 6.0, so i am wondering is this could of had any ill effects on my truck that i should look out for
Lead Driver
Joined: Feb 2011
Posts: 8,241
Likes: 155
From: L.A. (Lower Alabama)
You're right. The 10200 was for the 7.3. Here is an owners manual:
http://www.edgeproducts.com/product_...manual-166.pdf
There is a EZ ICP module for the 6.0 it's p/n EZ2000.
I'm not a tuner guy but I would pull it off and sell it and buy a proper tuner with some custom tunes if I needed more power. Lots of posts on here on the subject. Good luck!
http://www.edgeproducts.com/product_...manual-166.pdf
There is a EZ ICP module for the 6.0 it's p/n EZ2000.
I'm not a tuner guy but I would pull it off and sell it and buy a proper tuner with some custom tunes if I needed more power. Lots of posts on here on the subject. Good luck!
Thread Starter
|
Mountain Pass
Joined: Oct 2011
Posts: 106
Likes: 0
So i tried selling the chip to a guy with a 7.3 and it didn't fit into his truck. So i looked at the plugs on the chip it self and the male end of the chip fits into the 7.3 icp but the the female end fits my 6.0
Thread
Thread Starter
Forum
Replies
Last Post
