Shifting question? (shifting bracket and lever)
Thread Starter
|
Senior User
Joined: Aug 2011
Posts: 248
Likes: 0
Shifting question? (shifting bracket and lever)
I hooked up the shift ball and bracket to the transmission today (8ba engine/trans) but when I press on the clutch (while watching the movement on the selector on the transmission) I noticed it doesn't move a bunch..less than quarter turn.
Im not sure if its going into gear or not...is there a certain degree or turn the lever should be on... before being attached to the clutch lever?
Im not sure if its going into gear or not...is there a certain degree or turn the lever should be on... before being attached to the clutch lever?
Thread
Thread Starter
Forum
Replies
Last Post
Stephen67
1948 - 1956 F1, F100 & Larger F-Series Trucks
15
Jul 21, 2011 02:00 PM
IDIDieselJohn
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
7
May 28, 2009 07:20 PM
