I recently purchased a nice 66 Short Bed Custom Cab and it is missing the 3-piece trim set around the panel on each door. Does anyone have any or enough to do both doors, and be willing to sell them? Point me in the right direction....

My research shows that there is no remakes of these parts. Any help would be greatly appreciated.

Crowbar

 

ive seen some on ebay but not sure if there still there, i will check and post the link if i see them.

 

FTE member camperspecial65 may have these parts.

 

Bill,
Thanks. I will look him and get in touch. Have a great Sunday.

Crowbar

 

Thank you. I looked and found a partial set on E-bay. I am watching that item. The starting price was a little steep, for an incomplete set. My thinking at this time, with nothing to compare it too either. I had a set 17 years ago, I just did not know I would be needing them. "I should have kept those". My favorite hind sight statement. Thanks again.

Crowbar

 

I sent you a private message. check your PM's

 

I cannot figure out how to view PM from you. Please forward to kennethevans@***.net. Thanks

 

Thank you everyone for your assistance. I have been able to procure the parts I needed. Robert thanks again for helping me out.

Crowbar

 

No problem. You should receive them by the end of next week.

 

If anyone is needing these pieces, I can get about 5 complete sets at a bone yard in my area. Trucks that have not been robbed yet. Dash trim, door trim.. All Custom Cab Trucks.
Let me know.

 

Ive got scads of these pieces as well...varying conditions and I have BOTH types of upper trim...some used a phillips screw near the forward end...some didnt...as best I can tell 1964 didnt use the extra screw whereas 65-66 did...


- cs65