codes after hpop line changed
Thread Starter
|
Senior User
Joined: Mar 2005
Posts: 189
Likes: 0
From: Grantsville MD
codes after hpop line changed
I just changed my drivers side hpop line after the truck stalled on the side of the road. Now it takes longer to start and I have two codes that were not there when it stalled, p1212 and p0340. are these normal? it runs and sounds fine
Cargo Master
Joined: May 2010
Posts: 3,047
Likes: 10
From: Snohomish, WA
P1212 is ICP not at expected level which is possible since you changed the drivers IDE line and have air in the oil gallery. P0340 is camshaft circuit malfunction. If it is running fine, clear it and see if it comes back.
Your truck will be harder to start until you get about 50 miles on it and clear the air out of the heads.
Your truck will be harder to start until you get about 50 miles on it and clear the air out of the heads.
Thread
Thread Starter
Forum
Replies
Last Post
mutti_wilson
1999 - 2003 7.3L Power Stroke Diesel
6
May 18, 2016 06:37 PM
fluidp
1994.5 - 1997 7.3L Power Stroke Diesel
8
May 17, 2009 03:59 PM
