Is there a way
Thread Starter
|
Senior User
Joined: Dec 2010
Posts: 310
Likes: 0
Is there a way
Is there a way to adjust the clutch peddle, or do anything to adjust where the friction point begins? I have a new south bend clutch and it starts to grab about three to four inches from the end of the peddle. It doesn't feel right, almost like its a only partially engaging.
Thread Starter
|
Senior User
Joined: Dec 2010
Posts: 310
Likes: 0
Fixed it, I pulled the cap off the clutch master cylinder, then pulled the slave cylinder. Extended the slave cylinder as far as it would SAFELY go, then reinstalled. Guess I had a little bit of air in the line.
Senior User
Joined: Sep 2011
Posts: 279
Likes: 0
From: V
If im not mistaken arent the slaves on em self bleeding all you gotta do is put some fluid in the pump the heck out of the slave cylinder while its hooked up to the lines? atleast I could do that on my Jeep... never had a full size with a man trans... cept the KW 
Thread
Thread Starter
Forum
Replies
Last Post
89nolaf250
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
8
Jan 31, 2010 01:37 PM
Diesel Fiend
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
10
Aug 23, 2008 06:50 PM
1179
Clutch, Transmission, Differential, Axle & Transfer Case
6
Aug 31, 2006 07:03 PM
