97 psd icp
Hotshot
Joined: Aug 2006
Posts: 10,764
Likes: 39
Its easier if you loosen the fuel bowl . It can be done without if you remove one of the fuel lines
Remove the wiring , the 3/4 nut & the magnet . IIRC a deep 1 1/8 socket . I used a pair of vice grips on the socket ...
Remove the wiring , the 3/4 nut & the magnet . IIRC a deep 1 1/8 socket . I used a pair of vice grips on the socket ...
Fleet Owner
Joined: Aug 2004
Posts: 20,422
Likes: 197
From: AZ
I have electric fuel so its real easy. I use a sear deep dish 1 1/8 inch socket. A lot of sockets aren't deep enough. Some say they can get to it with a open end wrench but I never tried it. I think you have to remove your fuel bowl but I'm sure someone else will help you on this.
Posting Guru
Joined: Mar 2009
Posts: 1,799
Likes: 0
any word on your issue? my 1211 code came back with my brand new ipr a month later. runs the same, higher idol, 925psi but down right boogies when you put her on the floor. cuts out when the CEL is off. bout to burn this thing..
Thread Starter
|
Senior User
Joined: Jun 2006
Posts: 136
Likes: 0
From: Gaylord, Michigan
Actually, I haven't had much time to mess with it, or find the right damn one I need. What exactly is an edge filter? Some come with them, some don't! And apparently, the parts department at my local ford dealer is either staffed idiots, or they don't want to help me with part number interchange because I'm not going to give them 2-3 times more for it then what I can get it for elsewhere!
Postmaster
Joined: Nov 2005
Posts: 3,168
Likes: 10
From: San Ramon Ca.
Thread
Thread Starter
Forum
Replies
Last Post
dcelrod
1994.5 - 1997 7.3L Power Stroke Diesel
3
May 9, 2016 09:36 PM
