What is the difference?
Thread Starter
|
Junior User
Joined: Jul 2016
Posts: 88
Likes: 0
What is the difference?
Ive ran Torque pro on my 02 F250 w/ 7.3 and didn't get any DTCs but I ran FORscan Lite and got several.
Whats the difference and do I really have this many issues with my truck?
Thanks- Bombguy
Whats the difference and do I really have this many issues with my truck?
Thanks- Bombguy
FTE Leadership Emeritus
Joined: May 2014
Posts: 27,352
Likes: 5,946
From: Lake Hartwell, GA
Yes, you really do have the codes that Forscan pulled. Although, that is not uncommon and the codes should be reset or cleared and tested again after a short run cycle. Codes can stay stored for a very long time and might not be relevant any longer.
TP - Good to look at and used for monitoring
Forscan - Reliable and used for troubleshooting
Also, does IYAAYAS mean anything to you? My father was Ammo for 26 years in the USAF is where I know that acronym from.
Thread Starter
|
Junior User
Joined: Jul 2016
Posts: 88
Likes: 0
IYAAYAS... If you aint Ammo you aint ****.
Didnt have much need for the Moniker as I was Army EOD. I made things come from together and played with UXO( Unexploded Ordnance) things that didnt function as designed. Like the movie Hurt Locker but on a more realistic scale.
Anyway, Ive ran all the test that I can in FORSCAN , I have several codes but dont want to throw parts at an issue.
IT starts, it idles about 3 minutes it dies or it starts, i drive it and while comming to a stop sign it will die but start right up.
The following are new and OEM.
IPR, ICP w pigtail, fuel filter,fuel pump relay fuse, CPS(grey), oil change (15w40), batterys, 4x4 actuator vacuum,
What test should I run and what should I look for? I know the obviously answer is "Run them all" and "Report your DTCs" here
I have just ran the 1st test " Key on Engine Running on Demand Self test" it went through the paces and I though the truck was gonna blow up..
came back with P0476 Exhaust pressure control valve malfunction.
Didnt have much need for the Moniker as I was Army EOD. I made things come from together and played with UXO( Unexploded Ordnance) things that didnt function as designed. Like the movie Hurt Locker but on a more realistic scale.
Anyway, Ive ran all the test that I can in FORSCAN , I have several codes but dont want to throw parts at an issue.
IT starts, it idles about 3 minutes it dies or it starts, i drive it and while comming to a stop sign it will die but start right up.
The following are new and OEM.
IPR, ICP w pigtail, fuel filter,fuel pump relay fuse, CPS(grey), oil change (15w40), batterys, 4x4 actuator vacuum,
What test should I run and what should I look for? I know the obviously answer is "Run them all" and "Report your DTCs" here
I have just ran the 1st test " Key on Engine Running on Demand Self test" it went through the paces and I though the truck was gonna blow up..
came back with P0476 Exhaust pressure control valve malfunction.
FTE Leadership Emeritus
Joined: May 2014
Posts: 27,352
Likes: 5,946
From: Lake Hartwell, GA
IYAAYAS... If you aint Ammo you aint ****.
Didnt have much need for the Moniker as I was Army EOD. I made things come from together and played with UXO( Unexploded Ordnance) things that didnt function as designed. Like the movie Hurt Locker but on a more realistic scale.
Anyway, Ive ran all the test that I can in FORSCAN , I have several codes but dont want to throw parts at an issue.
IT starts, it idles about 3 minutes it dies or it starts, i drive it and while comming to a stop sign it will die but start right up.
The following are new and OEM.
IPR, ICP w pigtail, fuel filter,fuel pump relay fuse, CPS(grey), oil change (15w40), batterys, 4x4 actuator vacuum,
What test should I run and what should I look for? I know the obviously answer is "Run them all" and "Report your DTCs" here
I have just ran the 1st test " Key on Engine Running on Demand Self test" it went through the paces and I though the truck was gonna blow up..
came back with P0476 Exhaust pressure control valve malfunction.
Didnt have much need for the Moniker as I was Army EOD. I made things come from together and played with UXO( Unexploded Ordnance) things that didnt function as designed. Like the movie Hurt Locker but on a more realistic scale.
Anyway, Ive ran all the test that I can in FORSCAN , I have several codes but dont want to throw parts at an issue.
IT starts, it idles about 3 minutes it dies or it starts, i drive it and while comming to a stop sign it will die but start right up.
The following are new and OEM.
IPR, ICP w pigtail, fuel filter,fuel pump relay fuse, CPS(grey), oil change (15w40), batterys, 4x4 actuator vacuum,
What test should I run and what should I look for? I know the obviously answer is "Run them all" and "Report your DTCs" here
I have just ran the 1st test " Key on Engine Running on Demand Self test" it went through the paces and I though the truck was gonna blow up..
came back with P0476 Exhaust pressure control valve malfunction.
I was very familiar with EOD personnel in the USAF during my 5 deployments and being assigned to a tactical communications unit for a lot of years.
On to the codes thing.
Do you have a tuner? Some codes are set by certain tuners.
The only things you cannot monitor with the PCM are fuel pressure and EGT's. EGT is not your problem, but fuel pressure might be.
We have seen a weak fuel pump a few times that would allow for idle but die when applying throttle.
Speaking of that, have you checked the IVS and TPS both associated with the throttle assembly.
You have hit some of the typical fixes already, but not the right one yet.
Can you log data or monitor data as the engine is idling and dies?
Thread Starter
|
Junior User
Joined: Jul 2016
Posts: 88
Likes: 0
Didnt get a chance to log the data as she now wont stay running long enough to do but I have completed all the test in Forscan Lite on my phone and it found the following DTCs.
NO Tuner.... 2002 F250 Superduty 4x4 w/ 7.3 and 163k
only mods are a Banks cold air intake and an aftermarket , inline 34 row transmission cooler with Fan for Towing heavy trailers.
P0284
B2184
P0476
P1536
DTC in GEM is B1483
DTC in IC is U1027 and U1262
DTC in PCM is P1280,P1670,P0381,P0340,P0470
I understand that some of these codes may be the result of other issues.
NO Tuner.... 2002 F250 Superduty 4x4 w/ 7.3 and 163k
only mods are a Banks cold air intake and an aftermarket , inline 34 row transmission cooler with Fan for Towing heavy trailers.
P0284
B2184
P0476
P1536
DTC in GEM is B1483
DTC in IC is U1027 and U1262
DTC in PCM is P1280,P1670,P0381,P0340,P0470
I understand that some of these codes may be the result of other issues.
It's a Van Gogh
Joined: Feb 2010
Posts: 7,812
Likes: 1,335
From: Elk Grove, CA
One that jumps out to me is P0340, cam shaft position sensor. Easy and cheap to replace a CPS. Inspect the wires too.
Trending Topics
Lead Driver
Joined: Jun 2007
Posts: 7,760
Likes: 27
From: Hampton, Maryland.
FTE Stories
Ford Trucks for Ford Truck Enthusiasts
10 Things Every Truck Owner NEEDS (2026 Edition)
Michael S. Palmer
Rezvani's Latest Post-Apocalyptic Monster Is a Ford F-150 Raptor Underneath
Verdad Gallardo
Top 10 Most Expensive Ford Trucks Ever Sold on Bring a Trailer
Joe Kucinski
2027 Ford Super Duty Buyer's Guide (Every Model, Engine, & Package)
Brett Foote
Top 10 Ford Truck Tragedies
Joe Kucinski
AEV FXL Super Duty - the Super Duty Raptor Ford Doesn't Make
Brett Foote
Lobo Vs Lobo: Proof the F-150 Lobo Should Be Even Lower!
Michael S. Palmer
Ford's 2001 Explorer Sportsman Concept Looks For a New Home
Verdad Gallardo
10 Best Ford Truck Engines We Miss the Most!
Joe Kucinski
Thread
Thread Starter
Forum
Replies
Last Post
jdneal88
1999 - 2003 7.3L Power Stroke Diesel
16
Jan 2, 2017 12:35 AM
Fordenthusiasts
1987 - 1996 F150 & Larger F-Series Trucks
8
Jul 4, 2011 07:32 PM
seekfuntime
Explorer, Sport Trac, Mountaineer & Aviator
12
Nov 5, 2007 12:25 PM