I recently purchased and received the front driver side cab mount from Dennis Carpenter and noticed there was no hole drilled for the rubber mount and bolt. Is this normal and do I have to drill my own hole? Anybody know what size to drill it to or did I get one not drilled for some reason?

Thanks

 

It is normal, Some aftermarket units are not stamped as they can not control where you place it if the cab is off the truck.

Drill it to 3/4" to allow for adjustment.

Garbz

 

Thanks Garbz.. I appreciate it..

 

No prob. Also make sure you look at them as they are left and right and the floor does slope slightly to the rockers.

Garbz

 

You mean Left= Driver, Right= Passenger correct?

 

Yep as from the drivers seat.

Garbz