A 1978 bronco. The gearing will be as follows: 4.11 or 4.56 with 33 or 35" tires. I am the guy who blew the engine up the first time because the advance curve was way wrong for my application. Right now the curve is set up for a 1971 torino with 350 gears and 14" 60 series tires. alot less load i think. How much total and when should it come in. The engine will run around 4000-6000 rpm, but i still want to get it there with some good initial advance, since that is what these clevelands like, at least 16 if not 18 or even 20 on the initial. its a crane 529551, and i will have a funnel web intake and prob an 830 holley with annulars. any suggestions guys on this setup thanks.

 

14 to 16 to start with is good with 38 full on being the target by 3000 rpm's.