Hypertech users please come in.
Thread Starter
|
Posting Guru
Joined: Jun 2005
Posts: 1,803
Likes: 0
From: Amarillo, TX
I have been using Hypertech for 10 years+ And have never had any issues with them. From diesels to Corvettes.
But going with the Hypertech Extreme Energy programmer with the 6.0 I am having some weird results.
The truck seams to have "stock" power from idle to 2250 rpm and then the truck and engine takes off like a rocket ship. Sorta like a mean two stroke motor cycle with its power band. Its almost like the "programmer" does not take effect until the 2250 RPM mark.
Has any one seen this?
I also have been experiencing some strange shifting with the programmer.
I have contacted Hypertech and they were no help, said they had never seen these issues before.
But going with the Hypertech Extreme Energy programmer with the 6.0 I am having some weird results.
The truck seams to have "stock" power from idle to 2250 rpm and then the truck and engine takes off like a rocket ship. Sorta like a mean two stroke motor cycle with its power band. Its almost like the "programmer" does not take effect until the 2250 RPM mark.
Has any one seen this?
I also have been experiencing some strange shifting with the programmer.
I have contacted Hypertech and they were no help, said they had never seen these issues before.
Post Fiend
Joined: Oct 2005
Posts: 10,626
Likes: 7
From: Plano TX and Brentwood TN
I still say a programming issue. If it is that, not really a whole lot you can do, except send it to them and have them figure out what's going on or what if it's a common occurence, wait until they get a new firmware update fixing it.
However, if it's programming issue then it's the waiting game.
Thread
Thread Starter
Forum
Replies
Last Post
