Front plate relocation
Thread Starter
|
Laughing Gas
Joined: May 2006
Posts: 1,192
Likes: 0
From: Oakville, Ontario
Front plate relocation
I just installed a bull bar on my 2007 F250. But the front plate is covered. I would like to relocate the front licence place due to the local laws. How have some of you guys accomplished this and still make it look good.
Posting Guru
Joined: May 2003
Posts: 1,362
Likes: 2
From: Juneau, ALASKA
When I had a bull bar on my Bronco I moved it over to one side. Two other things I have seen done but wouldn't recommend or sure if legal are a guy bent his around the middle of the lower bar and riveted it in place so that it was wrapped around the bar. You could still read it and it didn't look that bad. Another truck the guy hung his from under the bumper on a piece of rubber so that it would flex when needed to.
Do you have a valance under your bumper could you mount it to that?
Every time I see your avatar I start staring at it and almost forget to read the post.
The Dodge line in your signature almost cost me a new keyboard do to flying coffee.
Do you have a valance under your bumper could you mount it to that?
Every time I see your avatar I start staring at it and almost forget to read the post.
The Dodge line in your signature almost cost me a new keyboard do to flying coffee.
Fleet Mechanic
Joined: Apr 2007
Posts: 1,433
Likes: 7
From: NH
Not sure what type bull bar you have but Westin makes this relocation bracket.
Amazon.com: Westin 32-0055 License Plate Relocator for Bull Bar: Automotive
Amazon.com: Westin 32-0055 License Plate Relocator for Bull Bar: Automotive
Thread
Thread Starter
Forum
Replies
Last Post
Mike Hannahs
1994.5 - 1997 7.3L Power Stroke Diesel
4
Oct 14, 2013 01:22 PM
suntaster
1967 - 1972 F-100 & Larger F-Series Trucks
15
May 6, 2009 07:36 PM
