Brake problem
Thread Starter
|
Elder User
Joined: Aug 2009
Posts: 946
Likes: 0
From: Clearfield County, PA
Brake problem
i put new wheel cylinders in the rear of my 76 250 because the bleeders were froze. I bled all the brakes and i still have none. The pedal gets fairly hard but will go the whole way to the floor with nothing. Im guessing it may be the master cylinder but not sure what else it would be. Any other ideas?
Thread Starter
|
Elder User
Joined: Aug 2009
Posts: 946
Likes: 0
From: Clearfield County, PA
I can push the pedal with decent pressure but it bleeds to the floor and yes i adjusted the brakes when i was done. Another question do you have to adjust the brakes over time with the wear of your shoes?
Hotshot
Joined: Apr 2009
Posts: 14,333
Likes: 247
From: Stanley, VA
You shouldn't have to readjust your brakes as long as the automatic adjusters are working.
If the pedal bleeds down it is probably the master cylinder but check the entire system for leaks first.
If the pedal bleeds down it is probably the master cylinder but check the entire system for leaks first.
